How To Fix Self Balancing Scooter Issues?

Self-balancing Scooter is the new and innovative technology product. The mechanism and technology which has been used in this scooter are not entirely developed. All the hoverboard are thoroughly tested before send it to the market and also company doing their best to give the great condition product.

How To Fix Self Balancing Scooter Issues

Even though people are trying to purchase the best self balancing scooter after a lot of researches, it is impossible to avoid some defects right?

Some issues in the hoverboard will able to solve by their own. Instead of people sent to the service center by using their warranty card. It takes a minimum of two weeks of time to resolve the problem.

So are you waiting for a couple of weeks to get the repair? Or solve it your own within a minute?

The common problems occurred in self-balancing scooter are,

  • Hoverboard Lost The Balance.
  • Pads Get Stuck On The Board.
  • Start Shaking Self Balancing Scooter.
  • Scooter Lost Contact With The Charging Port.

How To Resolve?

Hoverboard Lost The Balance

This problem occurs due to the unresponsive tilting. The red light starts signaling, and people can fix by their own. Here are the steps,

Step 1: Switch off your self-balancing scooter and make a double check.
Step 2: Make the board straight with the help of flat surfaces.
Step 3: Both sides of the boards should be aligned.
Step 4: Now, hold the power button for a couple of seconds.
Step 5: Once the light starts flashing release the power button.
Step 6: Allow the hoverboard to calibrate.
Step 7: Self-balancing Scooter is ready after finished the calibrate.

Pads Get Stuck On The Board

This problem occurs due to the hoverboard will not sense the rider feet. In this scenario, the rider should give pressure on the pads to unstuck. Try to get the designated position.

Before doing any operation with self-balancing scooter make sure your scooter is turned off. Remove or arrange the wire that any might in a possible way. Usually, this method will solve the problem.

Start Shaking Self Balancing Scooter

This operation is a little bit tough, and people who don’t have basic mechanic knowledge will lead them to trouble for your self-balancing scooter. So kindly use their warranty card instead of repair on their own.

Step 1: Turn back the self-balancing scooter.
Step 2: Unscrew and open the board.
Step 3: Make sure all the wire are fixed in their allocated space.
Step 4: Open the board and cut a little bit from the second rubber.
Step 5: Do the same for a First rubber too.
Step 6: Close all boards and start riding yourself balancing scooter.

Note: I’m not suggesting you do this on your own. Instead, you should use the warrant card to fix the issue is a better option.

Scooter Lost Contact With The Charging Port

The anyone can fix this. Before fixing the problem, you should know some basics about the mechanics.

Step 1: Choose the charging port side to open the board
Step 2: Unscrew the board, from a back side.
Step 3: Check all the wire are attached to the motherboard or not.
Step 4: If any loose occurs or reattached the wire.
Step 5: Finally, put up the screw and start charging your scooter.

I Hope above tips are helpful to fix the self-balancing scooter issue by their own.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes:

<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>